Whole-home connectivity
Structured wiring for audio, video, networking, security, lighting and shades, with no exposed cables anywhere in the finished home.
Prewire & New Construction · Phoenix + Marin County
Building or remodeling is the one time the walls are open. We plan and wire the house for audio, video, WiFi, lighting, shades and security now, so it is ready on move-in day and for whatever comes next.
The short version
Once drywall goes up, every speaker, camera and access point means cutting into finished walls. Before drywall, it is a planned cable run and a clean finish. That is why we like to be involved early, ideally while the plans are still on paper.
We work directly with builders, architects, electricians and designers, walk the framed house with you to confirm every location, and leave you with a home that is ready for the systems you want now and the ones you will add later.
What we do
Every low-voltage system in the house, planned together and homing back to one place.
Structured wiring for audio, video, networking, security, lighting and shades, with no exposed cables anywhere in the finished home.
Speaker wire for in-ceiling and outdoor speakers, plus video and network runs to every TV location, including above fireplaces and outside.
Cat6 to access points, offices and TVs, so great WiFi is built in from day one.
Wire for keypads, motorized shades, cameras, doorbells and door contacts, placed where you will actually use them.
Builders and designers get a partner who shows up on schedule and leaves a clean site.
We review architectural and electrical plans and mark up locations for every system before framing.
Our rough-in is scheduled with your builder and electrician so the work fits the build.
Before drywall, we walk the framed house with you to confirm every location, so nothing gets missed.
After paint, we come back to install speakers, TVs, equipment and controls, then program and test everything.


Built for the long run
Technology will change over the life of your home. The wiring plan should not have to. We add conduit to key spots like the TV wall, the equipment rack and outdoor areas, so when you upgrade in five or ten years, new cable pulls through without opening a wall.
How it works
Two locations
Same team, same standards, planned around the homes in each market.
Phoenix Metro, AZ
From custom homes in Paradise Valley and North Scottsdale to remodels across the Valley.
Marin County, CA
In Marin, remodels and rebuilds are when the walls open up.
Systems we design and install





As early as possible, ideally during design. We need to be on site before insulation and drywall for rough-in, but planning earlier means better locations and fewer change orders.
Yes. We coordinate directly with your builder, electrician, architect and designer so the low-voltage work fits the schedule.
Prewire anyway. Wire is inexpensive at framing, and we can wire for the likely options so you can decide later without opening walls.
Yes. Any time walls or ceilings are open is an opportunity. We wire the remodeled area and plan paths to the rest of the house.
Prewire, also called rough-in, is the cable that goes in before drywall. Trim is when we come back after paint to install the speakers, TVs, equipment and controls.
Phoenix · Marin County
Call Phoenix at (480) 416-8195 or Marin at (480) 570-6448, or send a few details and we will set up a walkthrough.